Kapture KPT-3300 - Setting up

Modified on Wed, 9 Jul at 11:06 AM

Inserting a Micro-SD card:

  1. Make sure dash cam is turned off and the screen is facing you
  2. Insert the SD card into the slot on the left side with the text on the SD card away from you
  3. Push the SD card in gently until you hear a click


Notes on installation:

  1. It is advised that the Dash Camera is installed near the rear-view mirror, at the top centre of the windshield for optimal operation.
  2. Make sure that the lens is within range of the windscreen wiper to ensure a clear view when it rains.
  3. Do not touch the lens with your fingers. Fingerprints left on the lens will result in unclear videos or photos. If photos or videos are blurred, please clean the lens gently with a microfibre cloth.
  4. Do not install the device on a tinted window. Doing so may damage the tint film and restrict the Dash Camera’s GPS signal
  5. Make sure that the installation position does not hinder or block the field of view or GPS signal.
  6. Only use the included cable to power the Dash Camera.
  7. The KPT-3300 is designed to be constantly connected to the included power supply.


Installing the dash camera:

  1. Connect the window mount to the top of the Dash Camera and rotate the locking nut clockwise until it is tight.
  2. Please follow the instructions on "Notes on installation" before continuing.
  3. Remove the protective stickers from the Dash Camera and the 3M Mount.
  4. Press the mount base firmly against the windscreen and hold for 30 seconds


Connecting to power:

Only use the included charger to power and charge the Dash Camera.

  1. Once the Dash Camera is securely installed on your vehicle’s windscreen, plug the DC Power Plug into your vehicle’s cigarette lighter.
  2. Run the power cable along the top and side of the windscreen and behind your glove box. Plug the Type-C USB plug into the Dash Camera and the DC Power Adaptor into your cigarette lighter port. 

Installing the rear camera:

  1. *Optional* Select the electrostatic film from the box and install it on the rear windshield in the recommended position as shown below. Please wipe glass before installation and push out the bubbles between the static film and the glass before installation.
  2. Remove the protective film from the rear camera base bracket and select either the top or the bottom of the rear window to position the rear camera.
  3. Press down on the base of the bracket by hand for 30 seconds to ensure that the sticker adhesive has attached to the electrostatic film. Connect the rear camera to the camera using the cable provided. Either run the cable through the roof lining or under the carpet underlay as shown below. The rear camera can rotate 360° degrees depending on the position and type of installation method. 
  • Method 1: thread the rear camera cable along the top of the roof lining and connect it to the Dash Camera. 
  • Method 2: lift up the car carpet and run the rear camera cable along the underlay of the carpet and connect it to the Dash Camera.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article