- Attach the optional detachable sun visor to the monitor. (as shown in image 1).
- Mount the monitor with the U-bracket and screws or by using the heavy-duty bracket with the 3M tape.
- Connect the RED wire (labelled ACC) to your chosen power source (either accessories or ignition). Both sources will be powered by a 12V or 24V battery, depending on the type of the vehicle. Refer to diagram on page 5.
- Connect the YELLOW wire (labelled B+) to a constant 12V or 24V power source. This connection can be made directly from the positive battery terminal or to the vehicle’s main fuse box.
- Connect the BLACK wire to the chassis, while the vehicle is on solid ground (earth). This wire can be connected to the negative terminal of the vehicle's battery.
- Connect the 6-pin camera cable to the monitor. To have a particular camera appear on the monitor when triggered, a (+) positive power feed is required. E.g.: The monitor’s brown trigger wire could be connected to the (+) positive reverse lamp wire. This will ensure the reverse camera will appear on the monitor when your vehicle is in reverse. This wire only has power when the reverse gear is in use.
- The HM-MNT will only connect to Hema cameras with a 6-pin Din connection. Please confirm your chosen camera is suitable for your vehicle with your retailer. Other cameras may require a 6-pin Din adaptor.
- When your vehicle is on, (either with the ignition turned on, or in accessory mode) your monitor will turn on automatically.
- The default display is CH1 Full Screen. By pressing the Mode button continuously, the display input can be changed with the following sequence:
- The Mode Switch will skip a channel if there is no camera connected to that channel input. When triggered, the Mode will switch to full display.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article