Hema Dash Cams - Setting up

Front camera installation:

1. Select the electrostatic film from the box and install it on the front windscreen in the recommended position as per the illustration. Please wipe the glass before installation and push out any air bubbles between the static film and the glass before installation.
2. Remove the protective film off the HM-DVR2 mount and position the Dash Camera in the middle of the electrostatic film. Press down the base of the bracket by hand for 30 seconds to ensure that the adhesive mount is attached to the electrostatic film and adjust the camera by rotating the barrel until it is capturing the entire road.
3. Run the Dash Camera cable along the top of the front windscreen through the A-pillar and around and under the glove box to the car's 12V/24V adaptor port. Connect the 12V/24V adaptor to the car power.

Rear camera installation:

1. Install the electrostatic film on the rear windscreen in one of the recommended positions as shown in the diagram. Please wipe and clean the windscreen before installation and push out any air bubbles between the electrostatic film and the glass before installation. 
2. Remove the protective film from the rear camera bracket and select either the top or bottom of the rear windscreen to position the rear camera.
3. Press down the base of the bracket by hand for about 30 seconds to ensure that the adhesive sticker is properly attached to the electrostatic film.
4. Connect the rear camera to the HM-DVR2 using the supplied rear camera cable. Run the cabling either through the roof lining or under the carpet.
5. Adjust the angle of the rear camera accordingly to ensure that you have a good rear view from your vehicle. 

Downloading the HEMA-DVR app:

Please see the page below to setup the HEMA-DVR app for the first time, if you have already done this, continue onto the next step.

Hema Dash Cams - Using the app

Formatting the inserted SD card:

1. Enter the HEMA-DVR app.
2. Please enter the Settings Section and select "Format SD card". 
3. The Dash Camera will format the Micro SD card and will provide an audio notification that the Micro SD card has been formatted. 
4. Alternatively, once the Micro SD card is inserted into the Dash Camera and connected to power, please press the blue power button on the Dash Camera 3 times rapidly. This will format the Micro SD card

Wiring:

Please see the manual below, or in the packaging from page 9 to 31 to learn more about the hard wiring process. This is a very delicate task, so if you have little to no experience in this, it is highly recommended that you seek a professional to do this for you.

This manual is relevant for:

• HM-DVR2
• HM-DVR22