How to Use the Clean Water Tank on the WetVac W31

How to add water and cleaning solution to the clean water tank:

1. Remove the clean water tank from the main body.
2. Open the rubber cover.
3. Add water until it reaches the MAX water line.
4. Add 2 bottle caps of cleaning solution into the clean water tank, then close the rubber cover.
5. Place the clean water tank back into the body.

Please refer to the picture below showing the above process:

Please pay attention to the following points:

• Do not add too much cleaning solution. Please only use water or eufy cleaning solution since using any other cleaning solution may cause severe damage to the vacuum.

• Do not add hot water into the clean water tank.

• Do not heat the clean water tank in a microwave.

• Do not add more than 3 bottle caps of cleaning solution as it will lead to excessive foam bubbles, and too much foam bubbles in the clean water tank will trigger voice alerts.

If you have any additional questions, please contact us for assistance.