Kapture KPT-2000 & KPT-2200 - Setting up

Inserting a Micro-SD card:

1. Make sure dash cam is turned off and the screen is facing you
2. Insert the SD card into the slot on the side with the text on the SD card away from you
3. Push the SD card in gently until you hear a click

Notes on installation: 

1. It is advised that the Dash Camera is installed near the rearview mirror, at the top centre of the windshield for optimal operation.
2. Make sure that the lens is within the range of the windscreen wiper to ensure a clear view when it rains.
3. Do not touch the lens with your fingers. Fingerprints left on the lens will result in unclear videos or photos. If photos or videos are blurred, please clean the lens gently with a microfibre cloth.
4. Only use the included charging cable to power the Dash Camera.

Installing the dash camera:

1. *Optional* Select the electrostatic film from the box and install it on the front windshield in the recommended position as shown below. Please wipe the glass before installation and push out the bubbles between the static film and the glass before installation.
2. Remove the protective film from the camera and position the DVR in the middle of the electrostatic film (optional). 
3. Press down on the base of the bracket by hand for 30 seconds to ensure that the sticker adhesive is attached to the electrostatic film.
4. Adjust the camera by rotating the barrel until it is capturing the entire road.

Powering the dash camera:

1. Run the dash camera cable along the top of the front windshield through the A pillar and around and under the storage compartment of the passenger seat to the car's 12/24V adaptor port. Connect the 12/24V adaptor to the car power.
2. See image below for cable management 

Rear camera installation (KPT-2200):

1. *Optional* Select the electrostatic film from the box and install it on the rear windshield in the recommended position as shown below. Please wipe the glass before installation and push out the bubbles between the static film and the glass before installation.
2. Remove the protective film from the rear camera base bracket and select either the top or the bottom of the rear window to position the rear camera. Press down on the base of the bracket by hand for 30 seconds to ensure that the sticker adhesive has attached to the electrostatic film.
3. Connect the rear camera to the front camera using the cable provided. Either run the cable through the roof lining or under the carpet underlay as shown below. The rear camera can rotate 360° degrees depending on the position and type of installation method. 

• Method 1: Thread the rear camera cable along the top of the roof lining and connect it to the KPT-2200 Dash Camera. 
• Method 2: Lift up the car carpet and run the rear camera cable along the underlay of the carpet and connect it to the KPT-2200 Dash Camera.